Click Each Service for more information.

Routine Schedule Services

3 MONTHS / 3,000 MILES Service

12 MONTHS / 15,000 MILES Service

24 MONTHS/ 30,000 MILES Service

48 MONTHS / 60,000 MILES Service

Other Services

VEHICLE INSPECTION - BUYER'S CHECK

BRAKE FLUID FLUSH

BRAKE INSPECTION AND SERVICE

COOLING SYSTEM POWER FLUSH

ELECTRIAL SYSTEM ANALYSIS:

FUEL INJECTION SERVICE

TUNE-UP ELECTRONIC IGNITION

MAJOR TUNE-UP ELECTRONIC IGNITION

TRANSMISSION FLUID FLUSH


Routine Schedule Services

Every 3 months or 3,000 Miles whichever comes first!
Lube, Oil & Filter Change with Free Safety inspection:

Every 12 months or 15,000 Miles whichever comes first!
Wheel Alignment, 4 Wheel Alignment if required:
Air conditioning service:

Every 24 months or 30,000 Miles whichever comes first!
Air Conditioning service with evacuate and recharge:
Cooling system power flush and pH balance: ( or anytime pH level is below 9.8 pH )
Tune-up (maintenance):
Fuel Injection Service (Motorvac):
Brake Fluid Flush (or anytime fluid contains moisture or is burnt ):
Transmission Fluid Flush: (or anytime fluid contains moisture or is burnt ):
Power Steering Fluid Flush: ( or anytime fluid contains moisture or is burnt ):
Rotate and Balance all 4 Tires :
Fuel Filter Replacement :
Change Clutch master cylinder fluid:
Change Standard Transmission / Transaxle fluid :
Change Transfer Case fluid 4 wheel drive.:
Change Rear Differential fluid 2 or 4 wheel drive :
Change Front Differential fluid 4 wheel drive :
Repack Front and/or rear wheel bearings when equipped:

Every 48 months or 60,000 Miles whichever comes first!
Cleaning PCV valve passages:
Cleaning of EGR valve and EGR valve passages:
Replace all Radiator and Heater Hoses :
Replace Thermostat:
Replace Drive belts:
Replace Timing Belt ( timing belt tensioners, water pump when driven by timing belt):
Replace Spark Plug Wires (Dist. Cap and Rotor apply where applicable):


Other Services

BRAKE FLUID FLUSH

INCLUDES:
1. Check brake fluid for moisture and contamination.
2. Inspect all hydraulic lines and hose.
3. Inspect Calipers and wheel cylinders.
4. Inspect Master cylinder and cap.
5. Clean out dirt and old fluid from master cylinder.
6. Flush old fluid out of master cylinder, calipers and wheel cylinders until clean.
7. Top off master cylinder with new brake fluid.
8. Road test vehicle for proper brake operation.

BRAKE INSPECTION AND SERVICE

INCLUDES:
1. Inspect visually hydraulic system for leak and condition.
2. Remove all wheels and inspect brake lining, brake hardware, and visually inspected wheel cylinders.
3. Remove brake dust and deglaze brake shoes.
4. Adjust brakes.
5. Adjust parking brake.
6. Lube backing plate and adjusting hardware.

COOLING SYSTEM POWER FLUSH

INCLUDES:
1. Pressure testing cooling system for leaks.
2. Flushing engine, radiator and heater core in both directions.
3. Bring antifreeze to -35 degrees.
4. PH balance coolant to between 9.8 and 10.5.
5. Visually inspect radiator cooling fan for proper operation.
6. Visually inspect heater operation.

ELECTRIAL SYSTEM ANALYSIS:

INCLUDES:
1. Inspect, battery connections.
2. Charge battery to full capacity.
3. Load test battery; and record readings.
4. Inspect alternator belt and adjust as required.
5. Perform alternator output test; and record readings.
6. Perform starter draw test; and record readings.
7. Test for draw on electrical system; and record findings.
8. Replace battery, if required.

FUEL INJECTION SERVICE

INCLUDES:
1. Clean fuel injectors.
2. Clean ISC / ASC motor as required.
3. Clean throttle body air intake.
4. Visually inspect fuel lines and fuel rail.
5. Pressure test fuel pump.
6. Test and visually inspect fuel pressure regulator vacuum line and connections.
7. Decarbonize intake manifold.
8. Decarbonize intake and exhaust valves.
9. Decarbonize combustion chamber and pistons.
10. Test exhaust emission.

TUNE-UP ELECTRONIC IGNITION

INCLUDES:
1. Replace spark plugs.
2. Check and adjust ignition timing as required.
3. Check and adjust curb idle speed as required.
4. Visual check of emission controlled related devices.
5. Visually inspect plug wires.
6. Visually inspect Distributor cap and rotor when accessible.

MAJOR TUNE-UP ELECTRONIC IGNITION

INCLUDES:
1. Replace spark plugs. 2. Check and adjust ignition timing as required.
3. Check and adjust curb idle speed as required.
4. Visual check of emission controlled related devices.
5. Visually inspect plug wires.
6. Visually inspect Distributor cap and rotor when accessible.
7. Clean fuel injectors.
8. Clean ISC motor as required.
9. Clean throttle body air intake.
10. Visually inspect fuel lines and fuel rail.
11. Pressure test fuel pump.
12. Visually inspect fuel pump pressure regulator vacuum line and connections.
13. Decarbonize intake manifold.
14. Decarbonize intake and exhaust valves.
15. Decarbonize combustion chamber and pistons.
16. Test exhaust emissions.

TRANSMISSION FLUID FLUSH

INCLUDES:
1. Road test for engine performance and transmission operation and shift patterns.
2. Flushing transmission cooler and cooler lines.
3. Flushing transmission valve body.
4. Flushing transmission torque converter.
5. Thorough cleaning of all internal parts.
6. Flush all contaminated transmission fluid out and replace all the transmission fluid with clean fluid.
7. Install transmission additive to revitalize transmission seals and O-rings.
8. Top off transmission fluid and road test.

VEHICLE INSPECTION - BUYER'S CHECK

33 POINT CHECK INCLUDES:
1. Air filter element.
2. Battery, terminals, cables and connection.
3. Drive belts.
4. Cooling system - Coolant and radiator.
5. Cooling systems - Hoses.
6. Distributor cap and rotor.
7. Engine oil.
8. Engine gaskets and seals.
9. Fuel filter.
10. PCV valve.
11. Power steering pump and hoses.
12. Spark plugs and wires.
13. Lights - Headlights, turn ssignal, stop, tail.
14. Wiper blades. 15. Front brake pads, bearings, lines and seals.
16. Rear brake pads/shoes, bearings, lines and seals.
17. Brake rotors/drums.
18. Emergency brake.
19. Brake hydraulic system lines and fluid.
20. Clutch adjustment.
21. CV axles.
22. CV axle boots.
23. Front differential.
24. Rear differential.
25. Exhaust system.
26. Power steering rack.
27. Steering linkage.
28. Front shocks/struts.
29. Rear shocks/struts.
30. Front tire condition.
31. Rear tire condition.
32. Alignment tire wear.
33. Transmission gaskets and seals.